Tury Fast Polaris Slingshot Throttle Controller – Quick Install Guide
Please make sure to read through all warnings and product manual at this link.
[FULL INSTALLATION GUIDE LINK HERE]
The Tury Fast Throttle Control Module is designed for a fast and simple plug-and-play installation on the Polaris Slingshot. No cutting, splicing, or permanent modifications are required.
Note: The two accessory wires are optional and not normally used. The brown wire is for Reverse Assist and the white is for lock signal, gps, or alarm system functions.
Estimated Install Time
* Approximately 10–30 minutes
Basic Installation Steps
1. Power Off the Vehicle
Before beginning installation:
* Park the Slingshot on a level surface
* Turn the ignition completely OFF
* Remove the key and allow the vehicle to sit for a few minutes
2. Access the Accelerator Pedal Connector
Locate the factory accelerator pedal assembly inside the driver footwell area.You will find the OEM throttle pedal wiring connector attached to the pedal.
3. Disconnect Factory Plug
Carefully unplug the factory connector from the accelerator pedal.
4. Install the Tury Fast Harness
Connect the Tury Fast harness inline:
* One side plugs into the factory pedal
* The other side plugs into the OEM vehicle connector
5. Route the Control Module
Route the controller wire neatly away from moving pedals or sharp edges. Use the included adhesive or mounting hardware to secure the controller in your preferred location.
6. Power On & TestTurn the ignition ON and verify:
* The controller powers up properly
* Throttle modes can be changed
* It is normal to get a check engine light. This is from the original pedal being disconnected and normally goes away after a few ignition cycles.
Start the vehicle and test throttle response carefully before driving normally.
Important Notes
* Professional installation is always recommended if you are unfamiliar with vehicle electronics.
* Secure all wiring away from pedals and moving components.
* Follow all safety precautions listed in the full manufacturer instructions.
Full Installation Instructions
For detailed diagrams, advanced settings, and complete manufacturer instructions, please refer to the full installation manual linked below.
iOS APP
Android APP